Liverpool Boiler Service and Repair – Gas safe registered – AJF Services 999 Service and repair boilers throughout Liverpool and surrounding areas. Gas safe registered
Gas safe registered and fully guaranteed.
During Boiler Service and Repair, testing the appliance is very important to ensure safety and efficiency.
Gas Safe registered engineers are trained in the most up to date use of testing equipment to ensure safety and reliability.
for a Liverpool Boiler Service and Repair call Andrew on 07831 5643541 today for a service or emergency repair
An expert Gas Safe engineer would know straight away what part of this gas meter installation does ot meet current standard. Don’t be fooled by anyone that says they know what they are doing if they are not Gas Safe Registered. Call 07831 564351 for an expert Gas Safe Registered Engineer to Service or repair your gas appliances today 07831 4564351 and ask for Andrew
For more info on servicing gas boilers follow this link Liverpool Boiler Service and Repair – Gas safe registered
Call 07831 564351 TODAY!!!!
Last year was the Biggest freeze we have seen for years and the cold winters seem to be getting worse in Liverpool and boilers and central heating systems are stretched to their limit to keep a home warm. But beware!!! Without regular safety checks and servicing the boiler can break down and leave you looking for Emergency Gas Boiler Repairs in Liverpool just when you don’t need it. That has the potential to leave you and your family in the cold and out of pocket. Especially if you call out British Gas. lol
It is important to have your Gas Boiler serviced and your heating system checked to ensure that it is working efficiently and to highlight faults and maintenance requirements before they happen and leave you looking for an engineer to perform Emergency Gas Boiler Repairs in Liverpool.
Your central heating system, Boiler and radiators and controls all work together to keep your home warm and reduce gas consumption while it does this with improved efficiency.
One or two small ‘Tweaks’ could help reduce gas consumption and improve it’s efficiency at minimal cost.
This is why you must carry out regular boiler checks is the risk of carbon monoxide. Carbon monoxide is a silent killer and poisoning kills year after year. It is a colorless and odorless gas which you could breathe in without knowing. Only with regular boiler checks will you know if there is a leak. It is also advised that you Install a Carbon monoxide alarm to give you piece of mind.
How Safe is Your Home
When the worst happens and your heating system and gas boiler starts to play up or breaks down completely you need to find someone fast to get it up and running again without breaking the bank. When you need emergency gas boiler repairs you must ensure that you pick the right person. . Finally, you’ll want to check your plumber is fully registered. Reputable Gas Engineers will be registered with ‘Gas Safe’ And insured. So when you need Emergency Gas Boiler Repairs in Liverpool just call me… I am Gas Safe registered. Insured up to £2 million pounds and have a background in training and assessing gas engineers for their gas assessments and qualifications. So you will be in good hands.
Call Andy on 07831 564351 for if you ever need Emergency Gas Boiler Repairs in Liverpool or just need your boiler and central heating system brought back to its optimum efficiency.
I carry out Emergency Gas Boiler Repairs in Liverpool and surrounding areas including full central heating Power-flushing and other gas appliance servicing and repairs.
I hope you liked this article and please leave a comment below.
For more articles about servicing boilers or Emergency Gas Boiler Repairs in Liverpool search this site and enjoy.
By 2020 the total electricity consumption of all glandless circulating pumps operated in the European Union for heating and air conditioning has to be halved. This also includes the normal small circulating pumps that we still have in many homes that pump water around our central heating systems . This is the objective of an EU ordinance under the European ErP (Eco-Design) Directive which now regulates the energy efficiency of this type of pump as of the 1 January 2013. Further requirements are being planned for the 1st August 2015 when these regulations will apply to the small pumps incorporated in combi and system boilers installed on new systems or in renovation projects where a new boiler is attached to an existing heating system.
An overall reduction of 11 million tonnes per year is estimated as these changes are thought to be likely to provide a reduction in EU-wide carbon dioxide (CO2) emissions.
In order to achieve this goal set by the European Commission, the EU ordinance prohibits the sale of technically outmoded, inefficient pump models from 2013 onwards. That included the basic static speed pumps that are outside of the boiler in domestic properties as of 1st Jan this year and pumps in Conbis and system boilers as of August 2015. So now you have to Install New CH Pump uk with an ‘A’ Rated Domestic Heating Circulator.
The important thing to recognise while determining which pump models can continue to be used from now on is the energy efficiency index (EEI).
Why do we now have to Install New CH Pump uk with an ‘A’ Rated Domestic Heating Circulator in Liverpool
As of January 2013, the limit EEI value of glandless circulating pumps installed outside the Boiler – external pumps – not those incorporated in combi or system boilers at this stage – will be defined as 0.27. Pumps will be better than the minimum requirements of the current A rated pumps as the energy efficiency classes specified at present will then become superfluous.
I the near future (August 2015) the EEI limit value will be reduced to 0.23. This will also apply to glandless circulation pumps, designed to operate in newly installed heat generators or solar thermal systems (integrated pumps). In the last implementation stage, from 2020 the regulations will also apply to the replacement of integrated pumps in existing heat generators and domestic boilers.
Many energy efficient single pumps offer potential electricity savings of up to 90% compared to standard pumps without speed control. They already comply with the first stage requirements for 2013 and with the limit values of the second stage of the glandless circulating pump ordinance due for 2015.
The new regulation on circulators will shift the market towards the intelligent high efficiency circulators that are capable of adjusting their performance to meet the specific needs of the heating system.
By 2020 across the 27 European member states, the EU Commission estimates that inefficient circulators are responsible for about a 20% share of household energy bills and removing them and replacing them with intelligent circulators could save as much as €2.2 billion – equivalent to the total annual electricity consumption of Ireland!
To make savings of up to 18% of your electricity Install New CH Pump uk with an ‘A’ Rated Domestic Heating Circulator in Liverpool. This along with other energy efficiency controls (that are set correct) could save you even more.
If you want to Install New CH Pump uk with an ‘A’ Rated Domestic Heating Circulator in Liverpool or contact me for any other reason just click on that text. Contact us
Every gas appliance from gas tumble driers and cookers to gas fires and boilers must be checked for safety at least once a year and serviced regularly.
In order to ensure your boiler is safe to use and efficient you should have a Annual Boiler Service and Boiler Servicing in Liverpool is easy to arrange by just calling 07831 564 351 and asking for me.. Andrew Foote…
Below are a few pictures of an Annual Boiler Service.
AJF Services provide the best Boiler Servicing in Liverpool and provide an Annual Boiler Service as part of the other services we provide. Take a look at what we do by clicking on the plumber
I was called out to service the boiler below
The following pics show me stripping the boiler down to remove any dust and to visually inspect the appliance before putting it back together again and checking the operation of the appliance.
Then we have to remove the burner and start hoovering and removing dust, debris and visually inspecting the boiler at all times.
Then we start to put it all back together again. Checking that the central heating gets hot, the system pressure is above 1 bar and that the hot water flow is good. finally testing operation gas pressures.
Now we need to do some checks at the gas meter.
We also need to check that there is an earth present at the meter and it is installed correctly
Finally test for leaks using leak detection spray
Now that the boiler is all back together again the appropriate paperwork needs to be completed and left with the home owner and then we are off to our next job…
I did not cover all that we do during a Annual Boiler Service and Boiler Servicing in Liverpool as you would have to take a full gas course. lol. But I think you get the idea that to do the job properly there is quite a lot to do. I can perform a full Annual Boiler Service and Boiler Servicing in Liverpool between 30 minutes and an hour. It all depends how dirty the boiler is.
Check out my other articles be going to my home page here >>> home page
To book me to perform an Annual Boiler Service and Boiler Servicing in Liverpool or any other plumbing or heating job just click on the link below
Get Your Boiler Ready for Winter now before it is too late and you end up with a heavy repair bill…
Yes it’s that time of year again when the Central Heating begins going on in houses across the nation including here in Liverpool, as the temperature falls and winter time is well and truly on the way.
Of course this is just the season when we need our central heating boilers the most – and it’s the actual season we’re likely to run into issues as well. The unexpected requirement we put them under can expose issues, and the dropping temperature can cause issues of their own as well.
Here are some guidelines to ensure you decrease the possibility of a faulty boiler this winter time.
1. Get your boiler serviced now
This is the best time for a boiler service. It will make sure everything is functioning effectively and if any maintenance that is needed, they can be done before the really cold weather sneaks in.
2. Turn your heating on at least once each week
Don’t delay for the really cold weather to hit before you put your Central Heating on. Even if you only run it on for a few hours one day per 7 days, it gives you a chance to see if there are any issues with it before you really need it.
Frozen pipes and joints can be a big problem for homeowners, avoiding the CH system and the boiler from functioning effectively. You should protect them all if you have not already done so – Including -if you have a condensing boiler- the condensate pipe if it runs through to the outside of your home.
4. Keep the heating on consistently but on a low setting
Lots of people only turn their Central Heating on in Liverpool when they really need it. However, when they do, they put it on high and it can take ages to warm the whole home. Then they turn it off again. Instead of doing this, have the boiler and Central Heating system on very low and keep it on for longer. It allows the home to accomplish a awesome temperature continually and it can mean less boiler issues because it will not have so much demand of it.
5. Your heating Boiler is ready for winter
Make sure you have our contact details in case your boiler breaks down when you least expect it. Print out our “Contact” page and put it close to your boiler.
As you can see, none of these guidelines are particularly unpleasant. Actually they should offer a fundamental element of getting your home prepared for the winter that is ready to pounce upon us… You will come to depend on your boiler a lot in the months to come, so ensure you put it on every now and again to make sure it all works and to get the best out of it when you need it most.
If you are in Liverpool and need a little help to Get Your Boiler Ready for Winter and ensure your boiler is in tip top condition then just get in touch by clicking on the image below and contact us now to arrange an inspection, service or repair today….
Are your partially heated radiators getting on your nerves? Is your boiler noisy and your home taking longer to heat than normal? These are all signs that we don’t want to see in our central heating systems over the winter months, and can often set the alarm bells ringing with fears of a broken boiler 🙁
It may sound scary, but don’t be alarmed! These are all symptoms that could suggest your central heating system is suffering from Sludge in your CH System. Over time, many central heating systems develop sludge, and AJF Services 999 will be able to diagnose and treat your system to eradicate the problem and treat is so it should not get that bad again.
Known technically as Black Oxide Sludge or magnetite, system sludge is the result of debris and corrosion of some of the components within your heating system. In other words your radiators are rusting and causeing a rusty sludge that slowly clogs up your system and starts making it worse and worse. that is what Sludge in your CH System is.
Sludge is caused by the rusting of radiators and other parts of the heating system.
As water flows past the debris, it creates a circular pattern moving the rusty sludge around your radiators. This causes cold spots in the centre of the radiator to appear where the sludge is moved to, leaving only the top, bottom and side of the radiator to warm your rooms.
Sludge in your CH System can also find its way into your boiler, restricting flow rates, and in rare, extreme cases causing failure to key components. It is something many central heating systems will develop in time and thesymptoms should not be ignored.
Sludge in your CH System presents itself in a number of ways. The tell-tale signs to look out for include:
Untreated sludge can lead to an increase in your heating bills, less heat, key components in your heating system being damaged and blockages. If you think you have Sludge in your CH System it is important to contact us now for more advice.
Treating system sludge
The treatment of heating system sludge requires thorough boiler cleaning which we carry out using mains water and a specialised cleanser, the system is power flushed using a big industrial pump. Professional treatment can take just a couple of hours for a basic system flush, through to a full day if each radiator requires individual treatment. The treatment type is dependent on the amount of sludge in your system and the problems it has caused.
When a new boiler is installed it is also important that the system is flushed to prolong the life of your boiler, in addition to treating the system with a chemical inhibitor to prevent future corrosion. The less sludge in your system, the more efficient your heating will be through the cold winter months.
So if your central heating system isn’t operating quite like normal this winter, don’t panic or ignore it, your system could just be in need of a good clean and a bit of TLC from me.
For more information about powerflushing and how it is done follow this link >> Powerflushing
We are based in Litherland Liverpool and this is what we have found.
Radiators can rust inside producing black iron oxide known as ‘sludge’. This sludge moves around the blocking pipes, valves and boilers (pumps/heat exchangers/diverter valves) causing all sorts of problems including:-
The solution is to Powerflush a Central Heating System and treat with corrosion inhibitor.
flush equipment, normally set up outside, connects to your and cleans the whole without having to take off all the radiators. WE normally just remove one radiator and do it all from there.
flush cleaner is added to the water and starts to loosen the rust. The is turned on and radiator surfaces checked for cold spots. By water through each radiator and vibrating cold spots the sludge inside is rapidly loosened. The sludge flows from radiators and is pumped out of the and replaces with clean fresh water.
All pipe-work, radiators and the boiler are flushed until water samples are clean and free from sludge and other deposits or debris
An effective corrosion inhibitor is added to the fresh clean water in the CH , radiators are balanced as required and checked that are all up correctly.
As you will find out I and my team are professional and friendly and will thoroughly flush your whole heating system providing you with :
I hope the above information helped you understand all about why you need to Powerflush a Central heating System in Liverpool and surrounding areas,
For more information on sludge in your follow this link >> Sludge
I look forward to chatting with you about how we can help.
For an Instant FREE quote to flush a in Liverpool
Call Andy on 07831 564351
For other ways to contact me click on the image below.